AR300U Xclone
No more illegal card cloning
Long Range Reader
AR300U Xclone is an anti clone ultra high frequency (UHF) long
range reader that can read up to 10 meter off air. Xclone features
Dual Security Protection (DSP) to ensure DOUBLE safety againts
unauthorized card duplication.
UHF card passive technology achieves long range without
requiring any battery. This help save our environments by
reducing battery usage.
Certified compliance to SIRIM 919 Mhz to 923 Mhz
frequency range as required by Malaysia MCMC regulation.
SIRIM certificate is available upon request.
No interference with other UHF card or sticker (example:
Touch ‘n Go RFID stickers or vehicle built-in UHF
transponder).
Compact size designed to look good at your guard house
entrance.
LED light at the bottom of reader to indicate reading status.
Features
More secure with DSP technology
There is a rising trend of illegal UHF card duplication which
post a critical security loop hole in building access control
system. Xclone is MAG proprietary Dual Security Protection
(DSP) technology to achieve following double protections:
1. SEEK CARD
Only scan and read MAG Xclone UHF system. This prevent
first attempt to duplicate with other unauthorised card or
stickers.
2. ANTI CLONE
2nd levels encryption makes it difficult to copy the same
card number.
More convenient with wider reading range
Enchanced wider reading range to accommodate sharp
corner with narrow path. Reading angle can be adjusted
by software at site to achieve a more defined desired
detection area elminating the need to loop detector.
More accurate reading
Reader will delay 2 sec before reading the next card. This
delay is to give enough time for first car to pass through
before reading the next oncoming car. Reader will resume
read the next card once the first car have exit the loop
sensor. This is important to avoid anti-passback error on
next approaching car due to false reading.
More intuitive to hold card
CDUS133L UHF card antenna coil is
designed to compensate small inductance
change so that you can hold the card at the
edge while still maintain same reading range.
This way of holding card is more intuitive.
Most standard UHF card requires you to hold
the card at edge. If your fingers covered a
small portion of the card surface, the reading
range will drop a lot. This is awkward.
Compatible with any brand controller
AR300U send out card number via standard wiegand
(WG26, WG34) interface output that is supported by most
access controller in the world.
CDUS133L, CDUM133L & CDUE133L cards are printed
with common WG34 and Entrypass WG26 format number
to allow convenient enrollment into any software without
additional dekstop reader.