AR300U
No more changing battery on your long range transponder
AR300U
AR3001J is an ultra high frequency (UHF) long range reader that can read up to 10 meter off air. UHF card passive technology achieves long range without requiring any battery. This help save our environments by reducing battery usage.
Certified compliance to SIRIM 919 Mhz to 923 Mhz frequency range as required by Malaysia MCMC regulation. SIRIM certificate is available upon request.
Lower reader and card cost with optimum reading range for more affordable parking access system.
Compact size designed to look good at your guard house entrance.
LED light at the bottom of reader to indicate reading status
Features
Advance anti-interference technology
Most standard UHF card requires you to hold the card at edge. If your fingers covered a small portion of the card surface, the reading range will drop a lot.
CDUS130L UHF card antenna coil is designed to compensate small inductance change and maintain reading range when our fingers convering the small surface on the card.
The hand position to hold other brand standard UHF the card at edge is ackward & not convenient.
CDUS130L allow you to hold the card at the corner. This way of holding UHF card is more intuitive & convenient
Anti-ambient reading
Reader will only read card once triggered by loop sensor when car passing through. When there is no car, reader will be disabled automatically to avoid wrongly reading unwanted cards nearby.
Anti-passback protection
Reader will delay 5 sec before reading the next card. This delay is to give enough time for first car to pass through before reading the next oncoming car. Reader will resume read the next card once the first car have exit the loop sensor. This is important to avoid anti-passback error on next approaching car.
Standard wiegand interface output
AR300U send out card number via standard wiegand (WG26, WG34) interface output that is supported by most access controller in the world
Same card number for dual frequency card
CDUEI 301- and CDUM130L dual frequency card are using the same number as printed on the card. Meaning that you only need to enroll 1 number into the access control system and it will work for both UHF and Mifare / EM readers. This save you a lot of time. Only 1 card number for each user will appear in access event report. This make it easier to review access control event report